balug:offered_wanted_hardware_etc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
balug:offered_wanted_hardware_etc [2019-12-23T03:05:01+0000] aaron_cohen Whole PC disposed of; case+peripherals avlble for re-assembling new PC |
balug:offered_wanted_hardware_etc [2020-07-02T16:17:33+0000] aaron_cohen free ethernet cables and SOHO router/switch available |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ^offered/wanted^general description/category ^make ^model ^serial number ^quantity^contact ^notes ^ | ^offered/wanted^general description/category ^make ^model ^serial number ^quantity^contact ^notes ^ | ||
| - | |wanted |memory DDR3 1333MHZ 8GiB | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|ECC preferred but not required. Help upgrade hardware BALUG & SF-LUG runs on most of the time | | + | |wanted |memory DDR2 667 MHz 1GiB ECC | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|Help upgrade hardware BALUG & SF-LUG runs on regularly but not most of the time (essentially anytime my laptop isn't available at home) |
| - | |wanted |memory DDR2 667 MHz 1GiB ECC | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|Help upgrade hardware BALUG & SF-LUG runs on regularly but not most of the time (essentially anytime my laptop isn't available at home) | | + | |offered |MidTower PC and monitor |Dell |PowerEdge SC430 | | 1|<acohen36@gmail.com> |Functional midtower PC containing 1.0 GB RAM with x86_64 antiX Linux installed onto internal 80GB SATA drive; functional 17" Dell monitor included; two std power cables, one std VGA monitor cable and one Cat5E ethernet patch cable included; keyboard and mouse are not included | |
| - | |offered |Computer case and peripherals |Antec MicroATX mini-tower computer case ||| 1|<acohen36@gmail.com>|Computer case; SU-300 switching power supply and extra p.s.u. (300W peak power); P-ATA CD-RW drives; P-ATA/EIDE hard disk drives capacity >= 120GB ; EIDE ribbon cables; standard power cables| | + | |offered |Computer case and peripherals |Antec MicroATX mini-tower computer case ||| 1|<acohen36@gmail.com> |Computer case; SU-300 switching power supply and extra p.s.u. (300W peak power); P-ATA CD-R drive; P-ATA/EIDE hard disk drives capacity >= 120GB ; EIDE ribbon cable; standard power cable and ethernet patch cable included | |
| - | | | | + | |offered |10/100 SOHO router/switch & power adapter|Linksys |WRT54GS v7.0 |CGNC1G8F9152 | 1|<acohen36@gmail.com>|Consumer-grade 5-port ethernet router/switch with DD-WRT firmware installed; original WAN port remapped to be the fifth switch port and wireless routing effectively disabled | |
| - | |offered |all-in-one inkjet/scanner/FAX/... |Brother |MFC-210C |U61083H4F319287 | 1|<Michael.Paoli@cal.berkeley.edu>|[[http://support.brother.com/g/b/spec.aspx?c=us&lang=en&prod=mfc210c_all|Specifications ...]] Makes for good scanner with [[http://www.sane-project.org/|SANE]] on, e.g. Linux (I used it for such some years ago); printing? - probably needs TLC to unclog + newer ink (cartridges) (of course) - printed fine when I tried it years ago, but not again years later - even with new ink cartridge, lots of media slots, FAX capable, I have archives of relevant materials from Brother web sites, some (bottom) plastic might be due bit of TLC too (wasn't ideally stored)| | + | |
| |offered |Gig unmanaged switch & power supply|D-Link |DGS-1005D |DR1914C001239 | 1|<Michael.Paoli@cal.berkeley.edu>|It's dead - but likely not both the power supply and the switch itself | | |offered |Gig unmanaged switch & power supply|D-Link |DGS-1005D |DR1914C001239 | 1|<Michael.Paoli@cal.berkeley.edu>|It's dead - but likely not both the power supply and the switch itself | | ||
| |offered |hard drive 1TB SATA |Seagate |ST31000NSSUN1.0T|9QJ3NDRE | 1|<Michael.Paoli@cal.berkeley.edu>|NOT for important data! 1000204886016 bytes, 1953525168 512 byte blocks/sectors The SMART data is scary (e.g.: ATTRIBUTE_NAME:Seek_Error_Rate FAIL:NOW RAW_VALUE:185787439933046), but regardless - I was able to do badblocks(8) -sw on the entire drive with zero hard errors. Maybe for your RAID-6 experiments, or that extra backup that's not at all critical, or ??? | | |offered |hard drive 1TB SATA |Seagate |ST31000NSSUN1.0T|9QJ3NDRE | 1|<Michael.Paoli@cal.berkeley.edu>|NOT for important data! 1000204886016 bytes, 1953525168 512 byte blocks/sectors The SMART data is scary (e.g.: ATTRIBUTE_NAME:Seek_Error_Rate FAIL:NOW RAW_VALUE:185787439933046), but regardless - I was able to do badblocks(8) -sw on the entire drive with zero hard errors. Maybe for your RAID-6 experiments, or that extra backup that's not at all critical, or ??? | | ||
balug/offered_wanted_hardware_etc.txt · Last modified: 2023-06-25T21:01:08+0000 by michael_paoli
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC0 1.0 Universal
