This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
balug:offered_wanted_hardware_etc [2019-12-23T03:05:01+0000] aaron_cohen Whole PC disposed of; case+peripherals avlble for re-assembling new PC |
balug:offered_wanted_hardware_etc [2020-01-18T14:01:44+0000] michael_paoli removed the obtained (from wanted); formatting tweaks |
||
---|---|---|---|
Line 11: | Line 11: | ||
^offered/wanted^general description/category ^make ^model ^serial number ^quantity^contact ^notes ^ | ^offered/wanted^general description/category ^make ^model ^serial number ^quantity^contact ^notes ^ | ||
- | |wanted |memory DDR3 1333MHZ 8GiB | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|ECC preferred but not required. Help upgrade hardware BALUG & SF-LUG runs on most of the time | | ||
|wanted |memory DDR2 667 MHz 1GiB ECC | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|Help upgrade hardware BALUG & SF-LUG runs on regularly but not most of the time (essentially anytime my laptop isn't available at home) | | |wanted |memory DDR2 667 MHz 1GiB ECC | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|Help upgrade hardware BALUG & SF-LUG runs on regularly but not most of the time (essentially anytime my laptop isn't available at home) | | ||
- | |offered |Computer case and peripherals |Antec MicroATX mini-tower computer case ||| 1|<acohen36@gmail.com>|Computer case; SU-300 switching power supply and extra p.s.u. (300W peak power); P-ATA CD-RW drives; P-ATA/EIDE hard disk drives capacity >= 120GB ; EIDE ribbon cables; standard power cables| | + | |offered |Computer case and peripherals |Antec MicroATX mini-tower computer case ||| 1|<acohen36@gmail.com> |Computer case; SU-300 switching power supply and extra p.s.u. (300W peak power); P-ATA CD-RW drives; P-ATA/EIDE hard disk drives capacity >= 120GB ; EIDE ribbon cables; standard power cables | |
- | | | | + | |
|offered |all-in-one inkjet/scanner/FAX/... |Brother |MFC-210C |U61083H4F319287 | 1|<Michael.Paoli@cal.berkeley.edu>|[[http://support.brother.com/g/b/spec.aspx?c=us&lang=en&prod=mfc210c_all|Specifications ...]] Makes for good scanner with [[http://www.sane-project.org/|SANE]] on, e.g. Linux (I used it for such some years ago); printing? - probably needs TLC to unclog + newer ink (cartridges) (of course) - printed fine when I tried it years ago, but not again years later - even with new ink cartridge, lots of media slots, FAX capable, I have archives of relevant materials from Brother web sites, some (bottom) plastic might be due bit of TLC too (wasn't ideally stored)| | |offered |all-in-one inkjet/scanner/FAX/... |Brother |MFC-210C |U61083H4F319287 | 1|<Michael.Paoli@cal.berkeley.edu>|[[http://support.brother.com/g/b/spec.aspx?c=us&lang=en&prod=mfc210c_all|Specifications ...]] Makes for good scanner with [[http://www.sane-project.org/|SANE]] on, e.g. Linux (I used it for such some years ago); printing? - probably needs TLC to unclog + newer ink (cartridges) (of course) - printed fine when I tried it years ago, but not again years later - even with new ink cartridge, lots of media slots, FAX capable, I have archives of relevant materials from Brother web sites, some (bottom) plastic might be due bit of TLC too (wasn't ideally stored)| | ||
|offered |Gig unmanaged switch & power supply|D-Link |DGS-1005D |DR1914C001239 | 1|<Michael.Paoli@cal.berkeley.edu>|It's dead - but likely not both the power supply and the switch itself | | |offered |Gig unmanaged switch & power supply|D-Link |DGS-1005D |DR1914C001239 | 1|<Michael.Paoli@cal.berkeley.edu>|It's dead - but likely not both the power supply and the switch itself | |