This shows you the differences between two versions of the page.
- | Both sides previous revision Previous revision Next revision |
- | balug:offered_wanted_hardware_etc [2019-05-24T03:01:31+0000] michael_paoli format tweaks |
---|---|
+ | Previous revision Next revision Both sides next revision |
+ | balug:offered_wanted_hardware_etc [2020-01-18T14:01:44+0000] michael_paoli removed the obtained (from wanted); formatting tweaks |
@@ Line -11,7 +11,6 @@ | |
^offered/wanted^general description/category ^make ^model ^serial number ^quantity^contact ^notes ^ | |
|wanted |memory DDR2 667 MHz 1GiB ECC | | | | up to 2|<Michael.Paoli@cal.berkeley.edu>|Help upgrade hardware BALUG & SF-LUG runs on regularly but not most of the time (essentially anytime my laptop isn't available at home) | | |
|offered | | |
|offered |all-in-one inkjet/scanner/FAX/... |Brother |MFC-210C |U61083H4F319287 | 1|<Michael.Paoli@cal.berkeley.edu>|[[http://support.brother.com/g/b/spec.aspx?c=us&lang=en&prod=mfc210c_all|Specifications ...]] Makes for good scanner with [[http://www.sane-project.org/|SANE]] on, e.g. Linux (I used it for such some years ago); printing? - probably needs TLC to unclog + newer ink (cartridges) (of course) - printed fine when I tried it years ago, but not again years later - even with new ink cartridge, lots of media slots, FAX capable, I have archives of relevant materials from Brother web sites, some (bottom) plastic might be due bit of TLC too (wasn't ideally stored)| | |
|offered |Gig unmanaged switch & power supply|D-Link |DGS-1005D |DR1914C001239 | 1|<Michael.Paoli@cal.berkeley.edu>|It's dead - but likely not both the power supply and the switch itself | |